P1S Poop Slide
Remixed by
Copyright Claim
P1S Poop Slide
Remixed by
Boost
74
114
37
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
7.7 h
1 plate
Open in Bambu Studio
Boost
74
114
37
10
472
207
Released
Comment & Rating (37)
All
Print Profile
0.2mm layer, 3 walls, 10% infill
fun and useful
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
slide could come up further to be flush with the front of the unit. very functional and easy print
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
It printed out great. Could use some inserts for magnets. Maybe I’ll make a remix.
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
interferes with filament spool with a full spool
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
ne colle pas asser a l'imprimante donc quelques boule sorte du slider
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Print works great on the printer. It does not like to sit behind the printer though I think it would be better if it had a few magnets in it or some type of screw system to mount it to the back.
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
works as intended, nice print
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
fits well and reasonably low material needed!
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
printed well with noo issues
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld