Customizable box with lid, latch and separators

Parametric rewrite of my old model (https://makerworld.com/en/models/598301).
Prints without supports and any additional parts, you can just insert the lid into box.

For separators and customizations please visit parametric model generator.

Tested print with Bambu PLA, for other filaments some tolerance adjustments may be needed.

Separators explained:

The first letter can be either v or h - that means vertical or horizontal separator.

After that, there's a number - offset in mm from the left side.

Next number is offset in mm from the top side.

Next is either a number or letter f - it can be the length of the separator in mm, letter f means it just takes full width if it's horizontal  or full height if it's vertical.

Next is the same but about the height of the separator from the bottom.

Each term is separated by commas, and if you need multiple box separators you just write them in line with spaces in between.
 
There's an example in the customizer: v80,0,f,f h80,40,f,f

That means two separators -

First:

v - vertical

80 - 80mm from the left side

0 - 0mm from the top side

f - full length

f -  full height

Second:

horizontal, 80mm from the left side, 40mm from the top side, full width, full height.