Studry screw-on poop shute
Copyright Claim
Studry screw-on poop shute
Boost
28
46
8
Print Profile(1)
0.24mm layer, 2 walls, 15% infill
2.4 h
1 plate
Open in Bambu Studio
Boost
28
46
8
0
128
74
Released
Description
This poop shute can be screwed onto the back of the X1C printer. It has these advantages
- Sturdy
- Doesn't take up a lot of space behind the printer
- Printed without supports, glue the 2 halves together after printing
- Has mounting holes to fix to the printer
- Sufficent drop angle and widen enough so that the poop doesn't get stuck on the shute (so constipation-free :-) )
- Collection system (not provided) is separate so that you can carry it to the dust bin without having to remove the whole poop shute
Comment & Rating (8)
All
Print Profile
0.24mm layer, 2 walls, 15% infill
It works fine. But had to use 400 Grid paper to get both sides together without little gaps. Also some connections to set it in place would have been nice.
Edit : I used 2 M3 Screws which came with the x1c , as the original ones in the case were to short.
(Edited)
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Tried it on my P1S but it's just barely touching the spool hanging on the back unfortunately. But I was looking to make the spool more accessible by moving it anyways. Just another reason :)
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Other Issues
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld