Mesh Purge / Poop Basket
Remixed by
Copyright Claim
Mesh Purge / Poop Basket
Remixed by
Boost
75
142
81
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Boost
75
142
81
3
399
376
Released
Description
I really liked the original version of this poop chute but there was gap inbetween the mechanical part and the basket, which the poop kept falling through. So I added an angled guide for the purged material.
Comment & Rating (81)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
A little tight to get on, but should hold is place well.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very nice looking and usefull
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
prints cleanly and works a treat
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great as described! catches very wel.
0
Reply
This is great it is very helpful
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
very nice print worked perfectly
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Failed on the first try, cleaned the bed and it printed just fine.
Bed Adhesion Issue:Make sure your bed is VERY clean otherwise it will pop off midway through the print.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fits very good and snug!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
cool print
no more puu on the floor and can see if its full or not
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld