Bambu Lab Cable Chain Guard
Copyright Claim
Bambu Lab Cable Chain Guard
Boost
173
323
153
GIF
GIF
Print Profile(4)
0.24mm layer, 3 walls, 25% infill
Designer
18 min
1 plate
0.2mm layer, 3 walls, 20% infill
15 min
1 plate
PLA for P1P
14 min
1 plate
High Quality - 0.08mm layer, 3 walls, 25% gyroid infill
27 min
1 plate
Open in Bambu Studio
Boost
173
323
153
3
610
534
Released
Description
Do you have a Bambu Lab printer?
Does the cable chain gets stuck on a screw when printing?
I have the solution!
Just print the cover with the arrow showing up and clip it on the sheet metal.
You want to pull it of again? Just push it downwards.
No supports for this model :-).
I recommend printing with PLA+/tough or PETG.
Tested this on my P1S.
Might also work on a X1? Someone might test it out.
Save your cable chain folks!
Happy printing.
Comment & Rating (153)
All
Print Profile
0.24mm layer, 3 walls, 25% infill
The designer has replied
1
Reply
oh damn is that with glowfilament?? or neon?
(Edited)2
Reply
Replying to @I3Design
fluorescent yellow from sunlu... and it gives the reflection of the LEDs and appears brighter 😅
0
Reply
Replying to @Ariox3D
do you have a led mod or just the standard?
0
Reply
Print Profile
0.24mm layer, 3 walls, 25% infill
Thank you.
The designer has replied
1
Reply
had any problems before?
my chain was rubbing crazy against the screw head..
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
thank you for the print. printed with standard settings using Sunlu PLA + in black
1
Reply
Print Profile
0.24mm layer, 3 walls, 25% infill
so far so good, used different print profile:
0.6mm nozzle
0.2mm layer height
0.62mm layer width
120% speed
basically 5 walls so no infill
PETG
So far so good
1
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Great design and easy to print.
1
Reply
Print Profile
0.24mm layer, 3 walls, 25% infill
👍
1
Reply
Print Profile
0.24mm layer, 3 walls, 25% infill
i like it
1
Reply
Print Profile
0.24mm layer, 3 walls, 25% infill
Imprimer en 0,12 pour une meilleur qualité. Après ça reste personnel. Impression parfaite !
1
Reply
Print Profile
PLA for P1P
Little model but it is great, thanks.
1
Reply
Print Profile
PLA for P1P
ok printed in black makes it a bit hard to see but it’s down near bottom left of pic. printed without any problems and looks like it’s going to fit perfectly
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld