Basic Bowden Tube Fitting, PTFE/4MM Plug
Copyright Claim
Basic Bowden Tube Fitting, PTFE/4MM Plug
Boost
2
7
3
Print Profile(1)
0.16mm layer, 3 walls, 20% infill
21 min
2 plates
Open in Bambu Studio
Boost
2
7
3
1
12
6
Released
Description
This is a basic PTFE plug or stopper that goes into the PC4-M6 or PC4-M10 pneumatic fitting.
No supports, any 15% infill is fine.
Comment & Rating (3)
All
Print Profile
0.16mm layer, 3 walls, 20% infill
Nice print to seal the extra ports on my filament dryer.
0
Reply
Boosted
Perfection in simplicity!
0
Reply
Just what I needed for the exact same setup!
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld