Minimal 8" x 8" Armorer / Parts Tray
Copyright Claim
Minimal 8" x 8" Armorer / Parts Tray
Boost
5
11
1
Print Profile(0)
Add the first print profile to earn points
Boost
5
11
1
0
11
0
Released
Description
- Minimal 8x8" Parts Tray.
- Some fillet on the inside edges to pull parts along the edge/wall upwards.
- Ribs on the bottom to more easily grab parts especially with flat surfaces
No supports needed
~15% infill is fine
Comment & Rating (1)
All
This is a nice big parts tray. I like that it's nice and solid and the ribs are helpful in picking up some parts... My first attempt to print it using a combination of PETG and ASA (on an X1C with the textured plate) failed when the tray body started to peel off the plate. I tried again using regular PLA and it printed fine.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld