Custom Yeti lid Sliders! Remix from a plain Yeti replacement lid I found on another site, however I made significant changes to correct dimensions (it was not the proper side, too small for lid track, cited magnets didn’t fit in the recess, etc). So I cleaned it all up, ensure a PERFECT Magnet fit (see source for magnets I found on Amazon below, but any round magnet that measures a true 8mm x 3mm should fit fine).
Print Details:
Use 8mmx3mm Magnets:
Pause at layer 24 to allow magnet install (ensure correct direction to attract towards lid, gentle push is all that is required, no glue, perfect snug fit!)
Adaptive layer heights
No supports
Painted - 2 Color (you can simply use this profile and select a single filament for the slider if you would prefer one color print.
.16mm layer height
Iron – All top surfaces
15% Infill
Gyroid
No brim
Be sure to check out my other uploads as I have created lids for a variety of Jeep models and other brands!
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.