DJI Mavic Mini / Mini 2 Case

Remixed by

DJI Mavic Mini / Mini 2 Case

Remixed by
Boost
52
110
15

Print Profile(2)

All
A1
P1S
P1P
X1
X1 Carbon
X1E

0.2mm layer, 3 walls, 15% infill
0.2mm layer, 3 walls, 15% infill
Designer
3.2 h
1 plate
4.7(13)

0.2mm layer, 6 walls, 25% infill
0.2mm layer, 6 walls, 25% infill
3.9 h
1 plate
5.0(2)

Boost
52
110
15
4
197
115
Released

Description

Smallest possible hard-shell protective case for just the Mavic Mini by itself. Now when I go hiking with my fanny pack, I can slip this in and it can't take up any less space. Plus it looks pretty darn cool.

This case truly "fits like a glove". There is virtually no movement inside when you gently shake the closed case. I designed it so that the drone rests on it's "belly" surface inside the case. There is no contact with the gimbal protector, and no weight bearing on the rotors underneath. No padding is necessary since nothing moves.

To "trap" the lower props, I put the drone on the table upside-down and arrange the bottom props and then lower the case down onto the drone before picking the whole thing up and turning it back over. Then arrange the props on the top and put the lid into place.
The Lid "clicks" lightly on with the protruding, tabs. In this case, "protruding" means, "take care or you'll snap them off". With any degree of care, the tabs should last and last.

Comment & Rating (15)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 6 walls, 25% infill
good
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
But I had to print the top part separately. I did this because it has to be scaled up a little, otherwise you can't close the box with the drone inside
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Problem with some overhangs on the lid
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Hervorragend endlich ist meine DJI gut verpackt
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Didn't manage to print in ABS but flawless print in PETG.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Support Issue
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply