Snap Together Tape Spool Version 6
Print Profile(3)
Description
This is a version update from Version 5 available here:
located at https://makerworld.com/en/models/1008987#profileId-1008392
NEW No handle Version 7 is available here:
https://makerworld.com/en/models/1299130-snap-together-tape-spool-version-7#profileId-1331095
Description:
This snap-together spinning tape measure spool has a spinning handle as well as the main spool section. No glue is required. I recommend PETG but this updated version may have greater strength than previous versions if printed with PLA.
Two different versions for 15mm or 20mm wide soft tape measures
Version 6:
Larger handle, easier to hold and stronger with larger swivel interface;
Handle print orientation (see image):
- PETG: handle may be re-orientated to be printed upright (see picture, standing).
- no supports required and smoother finish on handle;
- slightly weaker strength due to layer lines, this orientation may not be suitable for PLA; and
use you're slicer's ‘Lay on Face (F)’ command and invert the handle onto it's top surface (once assembled) prior to slicing
PLA: Default orientation (as downloaded) with handle laying on it's side with some minor supports (picture);
Orientate the handle using the ‘Lay on Face (F)’ to desired orientation prior to printing.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (83)