Bosch 18 V (Power for all) - wall hanger
Copyright Claim
Bosch 18 V (Power for all) - wall hanger
Boost
14
28
9
Print Profile(1)
0.2mm layer, 3 walls, 50% infill
Designer
30 min
1 plate
Open in Bambu Studio
Boost
14
28
9
1
50
46
Released
Description
Here is my minimalistic design for storaging the battery for Bosch 18 V power for all lineup (Bosch green).
Printed mine in PLA an they work fine since several years.
Mounted by 2 screws.
Battery slides in from the top, without securepins or something simmiliar.
- No Support needed.
- Mount with 2 x 2,5 or 3,0 mm screws
- arrow points down
- arrow shows the direction to put in battery
Just print it…
…put the battery in…
…pull the battery out…
Comment & Rating (9)
All
Print Profile
0.2mm layer, 3 walls, 50% infill
Wonderful model. Thank you very much 😊
0
Reply
Could you adjust distance from hole to hole from 34mm to 30 mm? Then I can mount it on a metric pegboard.
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 50% infill
Nice, simple and effective. printed 4
0
Reply
Print Profile
0.2mm layer, 3 walls, 50% infill
Its Ok
0
Reply
Print Profile
0.2mm layer, 3 walls, 50% infill
Perfekt
0
Reply
Print Profile
0.2mm layer, 3 walls, 50% infill
Strength Issue
0
Reply
Print Profile
0.2mm layer, 3 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 50% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld