Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
40 min
1 plate
Boost
99
232
37
4
324
249
Released
Description
This clip is designed to attach cables to the wall.
There are two models, one with holes to screw it to the wall and one with a smooth surface to use double-sided tape.
It has a locking mechanism that allows you to close and open as you like.
It is strong enough not to break.
It should be printed sideways.
Comment & Rating (37)
All
The print profile is no longer public
Works well and strong.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
These printed well and would seem to work well although I haven't used them yet.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
It is good for our cables.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
nice clip, holds strong and was a quick clean print
The designer has replied
0
Reply
thanks for the feedback!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Works great but was very tough to undo when fully clicked in. Maybe a thinner version would be nice.
0
Reply
Works great
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Printed well with Bambu pla cf
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Works well for putting larger cables along jousts. No hammering and easy to install
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Très bon modèle de base et bon profil d’impression propre et même boostable en mode sport sans problème
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (2)
© 2024 MakerWorld