Search models, users, collections, and posts
lid stop
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
17 min
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
19 min
1 plate
Open in Bambu Studio
Boost
0
5
2
0
16
7
Released
Description
Install this under the stock lid handle. This will hinge into place propping the lid open. It also double as a nice handle to open and close the lid. No supports needed. I printed in abs, and petg, and it hinges perfectly. Any filament should work. Version 2 is wider, but they both work good.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)