A1 HSW System V2

This is the somewhat anticipated V2 of the A1 HSW system! 

V2 features several upgrades:
1. The corner bracket is tougher, with a rear wall on the exterior and back mounting plates of the bracket to handle the load of all the gadgets you are going to hang from them.
2. The corner bracket now has some help! The side bracket and top bracket add just the little extra bit of stability you need to keep your honeycomb from wobbling during printing. Print an extra side bracket if desired to add even more support!
3. The corner and side brackets now feature a back mounting panel for a double line of HSW honeycomb! This makes it feel just a little bit more like traditional HSW so you don't feel left out.

Assembly

Assembly is basically the same as for the V1 HSW. Just slide the brackets onto the A1 as pictured and then wiggle the honeycomb lines into place. A dab of hot glue is all it takes to make the installation of the honeycomb lines permanent. Just be careful not to get glue inside the hexagons so you don't interfere with the locking mechanisms of any attachments that you later install.

Print Material Update

I printed my brackets in PETG-HF and they worked great but it was pointed out to me that the model was not compatible with PLA. A piece near the top bar would break consistently during installation. After some great recommendations from @wlwl, I have published a print plate compatible with PLA where the corner bracket has been modified to still hold up when printed in PLA.

I enjoy designing but I am fully aware that my models could be improved. If you have trouble with this or any of my designs, please include feedback with your ratings so I know what to work on. If you really like this design and want to see more like it, please reach out and let me know what you'd like to see! I love reading comments!