Sunflowers

I've always found my A1 remarkably stylish🤖, almost excessively so, to the point where it felt slightly incomplete. Therefore, I decided to bestow upon it a well-deserved accolade🌷 for its tireless service!

This sunflower design draws inspiration from Takashi Murakami's iconic sunflower, adapted to suit FDM printing capabilities and my specific printer.

 

Model Description

• This is a replacement accessory for the extruder wheel attachment, designed for the A1 series.

Printing Recommendations

1. Printable on all models.
2. Common PLA and PETG filaments are suitable; a complete print takes less than two hours.
3. I haven't specified filament colors, as you can mix and match them freely, including the quantity and order, to create your own unique floral arrangement!
4. If you'd like to replicate the filament colors shown in the images, feel free to ask in the comments; I will respond promptly.

 

 

Assembly Instructions

Total: 4 trays, 16 components

 

 

First, assemble the sunflower

Insert the petals into the tray in your preferred order

Next, install the smiling face; insert filament strands for the eyes.

Finally, tighten the screws to complete the flower assembly

 

Now attach the flower to the extruder

Before replacing the extruder wheel attachment, please cease printing! Or power down!

This prevents potential damage during installation.

 

Refer to the official images for guidance on disassembling the front cover

 

Remove the original component and the transparent cover inside the front cover

Finally, reinstall the front cover, then attach the sunflower. Gently press it into place.