Pneumatic Die Grinder to Router conversion
Copyright Claim
Pneumatic Die Grinder to Router conversion
Boost
15
11
1
Print Profile(2)
PLA 0.24mm layer, 6 walls, 25% infill
Designer
2.7 h
1 plate
ABS 0.24mm layer, 6 walls, 25% infill
Designer
2.9 h
1 plate
Open in Bambu Studio
Boost
15
11
1
0
23
6
Released
Description
Base plate to convert a commonly available pneumatic die grinder into a router. I made this when I had to chamfer a lot of edges of plywood sheets for use in a project, and we had a compressor to run a lot of equipment. Slips on most common die grinders and fastens with a single M6x25 screw, two washers and a nyloc nut.
Printed in PLA, but als did one in ABS but it is not really needed.
Hardware needed
Screw M6 x 25mm
Nyloc nut M6
2x Washer M6x10
Comment & Rating (1)
All
Print Profile
PLA 0.24mm layer, 6 walls, 25% infill
Prints and works great Favorite tool in the shop.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld