Update Log

20 Dec 2023 - Creation

Description

This is a remix of the Hygrometer for AMS from @lloydliu (Original Creator) and @ultrajaxel (Remix Creator)

You may download the print profile for best results or the parts individually.

The original files have been though changes and the hygrometer provided does not quite fit. I have modified and tested them to SpaceSheepEngineering's quality standards.

The original designed lids were partially meshed or full solid. I have modified and included a fully meshed lid for personal preference. The fully meshed lid have been tested with Bambu Basic PLA on Textured Plate.

If printing with multiple parts, take note that the lid's edges must be 180 away from the cases. Otherwise there will be a chance of failed print.

Please download the print profile for best results

Printing/Instructional notes

Please remember to remove the supports inside the case of 4R2_0

Based on where your geographical location is, Singapore for my case, ambient daily humidity is around 74%. I find having the hygrometer case in the middle of the AMS and not filled with slica beads for the most accurate results.

Remarks

• Check out my other designs here - Link
• Check out my collections of accessories for X1/P1 Series - Link
• For a suggested full set, you will require:
  • 1R2_0 - Slim Case (qty2) - (renamed) Previously “Drybox_slim_fixed.stl” from Original Creator
  • 2R2_0 - Slim Cover (qty2) - (renamed) Previously “Cap_slim3.stl” from Original Creator
  • 3R2_0- Wide Case (qty2) - (renamed) Previously “Drybox_wide3.stl” from Original Creator
  • 4R2_0 - Wide Case (Humidifier) (qty1) - Modified“Drybox (Wide) [Hygrometer].stl” from Remix Creator
  • 5R2_0 - Wide Cover (Solid) OR 6R2_0 - Wide Cover (Meshed) (total = qty3) - Modified “Cap_wide2.stl” from Original Creator
  • 1x Hygrometer (45mm Diameter and 15mm Depth)
    • 44mm Diameter Hygrometer works as well, as the mounting clips are the same.
• xR2_0
  • x represents a integer for ease of naming
  • R2 = Revision 2
  • _0 = Design 0