4 by 6 picture frame ornament by smith190

smith190

Household>Decor

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.12mm layer, 2 walls, 15% infill

Designer

1.2 h

1 plate

5.0(3)

Boost

Released

Description

A Christmas tree ornament that holds a 3 by 5 inch photo.

Comment & Rating (6)

@zackza

not good, photos fall out! needs a small extra piece sticking out just like a flat long rectangle lip to keep it in place, and a negative long skin box making a gutter for the photo to rest on... and back part should just be a big x or 3 bars

(Edited)

@zackza

but it does work if you just bend/roll your 4x6 glossy photo paper the other way so it will bend inside correctly and stay put and not fall out. but that shouldn't be necisary! it is so close maybe I'll add a profile of one that works better with 2 simple little tabs and a built in folding stand perhaps j could add from another design

@zackza

Print Profile

0.12mm layer, 2 walls, 15% infill

it's ok... I had to bend my 4x6 to get it to stay and not fall out because theree no little tabs to keep it in place, I'll maybe upload profile showing what needs to be added for the photo to rest properly and be held in place by X shaped backside brace! but thank you for the low filament I'll still give 5 stars because maybe it's just my photo paper

@csdugnolle

Print Profile

0.12mm layer, 2 walls, 15% infill

@zackza

probably the best in terms of smallest fimament on makerworld at 33g other frames are like 200g ro 500 g , but I'd like one without hook or hook hidden on back, just like a hole, for the nail, and then like a stand?

(Edited)