Horse
Copyright Claim
Horse
Boost
44
76
18
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
46 min
1 plate
Open in Bambu Studio
Boost
44
76
18
0
317
195
Released
Description
The model is divided into three pieces so that you can print it without the need for support. However, you will need to assemble it by gluing the pieces together after printing.
Comment & Rating (18)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
i have yet to get this to print, supports or none.
1
Reply
Is it possible to download the whole model? So I can slice it in Slicer?
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
good profile
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
tail broke off while printing, looks great otherwise
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
The horse’s tail didn’t print correctly - it detached during printing. Also, I had difficulty glueing the two horse valves together, would perhaps prefer to print the whole horse with support vs trying to glue it. Finally, the horse wouldn’t stand on its own. with only two points of contact.
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Bed Adhesion Issue:it’s not sticking to PEI correctly. using bream is helping.
The designer has replied
0
Reply
please make sure that you clean the plate before hitting print
(Edited)0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld