Zip Tie Mount Block
Copyright Claim
Zip Tie Mount Block
Boost
26
65
11
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
11 min
1 plate
PLA 0.20mm
11 min
1 plate
Boost
26
65
11
0
103
81
Released
Description
use this holder with a zip tie and tidy up them unsightly wires
fix to any surface in conjunction with a double sided sticky pad or a small screw
fits cable ties upto 5mm width
Comment & Rating (11)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
nice design, thanks!
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Awesome little useful print.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Slightly tricky to get the zip tie past the screw, could do with a bit more height, worked well though
0
Reply
Print Profile
PLA 0.20mm
it works, nice and quick
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Strength Issue:Unfortunately the strength of the resulting print was not sufficient such that the cross tie bars in the structure failed while tightening up wire ties.
The designer has replied
0
Reply
sorry to hear you are having problems, these cable holders are not designed to be fully tightened it is just not necessary in order to keep a cable in place
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
PLA 0.20mm
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld