• Even 1 clip will move your wiper away if placed in the center → use more clips for longer wipers
• Wiper edge does rest in the empty space, so the rubber is not deformed
• Bottom is rounded and elevated, to make release of frozen clip easier
• Use with colourful filament for better contrast :)

Printing instructions:

• only 6.7grams of filament needed
• print on its side, no brim, no supports
• use maximum layer height - pictured is 0.32mm @ 0.4mm nozzle
• use 4 perimeters

Version history:

v1.0
3.12.2023

• initial release