VX 001 - WOW

----2025.6.7 Tip：Ignore the errors, they are nothing.

----2025.2.16 Upload foot part: Mimiron Part 3, Leviathan Mk II (Fully Movable), [V-07-TR-0N] finally comes.

----2025.2.14 Update. Added waist connector reinforcement hip3, just print 1 and press it into the waist position to make the gears bite tighter than before, so the body won't wobble even when the bottom Leviathan Mk II is moving.

----

Body parts of Mimiron boss fight in World of Warcraft, VX001.

About Print Profile:

• Some parts are preset with the necessary supports, most parts do not require supports.
• PETG, PLA+, and PLA can all be assembled properly. PETG or PLA+ is recommended for shoulder & neck & hip to ensure that they do not break during installation.

About Assembly:

• See the Installation manual for detailed assembly instructions.
• All slots have been optimised and normally no pre-treatment is required for the assembly process, but tolerances vary between filaments, so whether to sand or glue or not will depend on the situation.
• Some of the joints are serrated and will be a little tight on the first turn, turn them a few times to let the serrations break in, then they will fit better.
• The shoulder joint on the body and the hands are printed in one piece,  for initial use you need to follow the directions in the picture below to unlock the joints.

If you have previously printed Mimiron's Head (Fully Movable), you can replace the bottom connector of the head with the neck part from this model to connect it to the body as shown.

My other works: