Search models, users, collections, and posts
Cable Management Box
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
10.3 h
2 plates
Open in Bambu Studio
Boost
301
1077
53
43
986
467
Released
Description
Cable Management Box by:“Borderbox_7414” BambuStudio -Ready!
-Hide your power strips with this simple and sleek box. Doubles as a display shelf!
-Normal sized cable box as found on the market. (100mm deep x 398mm wide x 135mm height)
-Choose a textured build plate for a nice look for the lid!
-Friction based assembly! (see pictures)
-Assembly: There are 7 “friction clips” in total that hooks the parts together.
-This is a big and flat print. Warping is a possible outcome. Glue on the build plate helps a lot too and I recommend that you use it while prinding the base! If you are using any filament branding other than BBS - Follow the nozzle and build plate temperature recommendation by the company you're using to prevent warping!
Prints fine with BBL PLA. Other fillaments shouldn't be at problem!
Made by: “Borderbox” on Printables!
-Brim
-15% Infill (Gyroid)
-0,2mm LH
-2 walls
-0,4 nozzle
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (53)