Marble Run for bricks

Bricks compatible marble run for marbles up to 12 mm diameter. 

The marble run is compatible with all popular manufactures of bricks (for example the well known company from denmark).

I just put one piece of each part into the print profile. You have to multiply the needed parts by yourself.

The marble run contains the following parts:
 

Dimensions: 02x02 (Standard Print Profile)

• Start Tower
• Start and End
• Straight
• Straight with slope
• Curve
• Curve with slope to left
• Curve with slope to right
• Crossing
• Tunnel (Turn model to the side and enable support)
• Tunnel with a curve (Turn model to the side and enable support)

Dimensions: 02x03 (Standard Print Profile)

• Straight
• Straight with slope

Dimensions: 02x04 (Standard Print Profile)

• Straight
• Straight with slope

Dimensions: 02x06 (Standard Print Profile)

• Straight
• Straight with slope

Dimensions: 03x03 (Standard Print Profile)

• Curve
• Curve with slope to left
• Curve with slope to right

Dimensions: 04x04 (Standard Print Profile)

• Curve
• Curve with slope to left
• Curve with slope to right
• Straight with curve to right
• Straight with curve to left
• X-Crossing
• 2 to 1

Dimensions: 04x06 (Standard Print Profile)

• Curve to left an right
• Straight and Curve to left an right

Dimensions: 06x06 (Standard Print Profile)

• Catching Tray with opening in the middle
• Catching Tray with opening on the left side
• Catching Tray with opening on the right side

Dimensions: 08x08 (Standard Print Profile)

• Wormwhole with opening on the left side
• Wormwhole with opening on the right side

Flex Tracks (Standard Print Profile - Print with TPU)

• 02x12 - Flex Track
• 02x16 - Flex Track
• 02x20 - Flex Track

Speedup-Hammer (Strength Print Profile)
Give your marble new speed.

• Hammer_Station - The base for the hammer
• Hammer_Halter - The connector for the basement and hammer
• Hammer_Hammer_EU - For EU 2 Cents coins
• Hammer_Hammer_US - For US 1 Cent coins

Switch (Standard Print Profile)
Change the direction of the marbles. The marbles must not be too fast.

• 04x06_Switch_Bottom
• 04x06_Switch_Top

Multistart (Standard Print Profile)
Start at the same time with up to 4 marbles.

• Multitsart_Bottom
• Multistart_Top

Gauss Canon & Looping (Strength Print Profile)
Give your marble new speed.

• 02x06_GaussCanon_3mm (Part-List: 1x B-CA010) 
• 02x06_GaussCanon_6mm (Part-List: 2x B-CA010) - Very Strong
• Looping (Works only together with the Gauss Canon - 6mm)

Transfer (Standard Print Profile)
You can adjust the length of the connector yourself in your slicer (only change the X-axis)

• Transfer_Bottom
• Transfer_Middle
• Transfer_Connection - You can adjust the length yourself in your slicer (only change the X-axis)
• Transfer_Connection_2 - You can adjust the length yourself in your slicer (only change the X-axis)
• Transfer_Top

Ferris Wheel: Bring your marbles back to the top

• Ferris Wheel & Parts (Standard Print Profile)
• Ferris Wheel motor upgrade (Strength Print Profile)
  Part-List: 1x B-LA008, 1x B-XC004, 1x B-IA004