End strip for self printed skadis boards

I've printed a ton of AU3D's screwable Skadis boards ( https://makerworld.com/de/models/418809 ) this part was necessary so I could finish my Skadis wall to my workbench so I made it.

This should for one look nice but also avoid small parts like screws falling in the gap and getting lost.

I made the strip interlocking so there is no gap between them wich should look nicer but also prevent replacing one gap with another.

if you need other sizes let me know and I´ll upload print profiles for them (I have it all parameterized so it´s not much work) I was thinking about putting the smallest board size (80 mm) up as well because that one could maybe be stretched up but I'm unsure the quality will hold up in that case.

As it is it´s for 10mm spacers and lifts the board 10mm from the bench / table.

Usage:

Print one right and one left end and as many middle parts as you need them, you can glue them to your Skadis boards for ease of mounting but it's not necessary to do so.

I would recommend to start at the bottom unlike I did with starting at the top this should give you a nicer look and more functional interface between the boards going up. (in my picture you can see that I would actually had needed to put the boards in the next level the other way around in order for them to work properly with the smaller ones