Panda Coaster

Designed 3 coasters that include the following animals:

• Panda
• Red Panda
• Binturong

I printed them with AMS and it takes about 1 hour to print each coaster.

The size of each coaster is 95mm x 95mm x 2.40mm

How to print without AMS:

There are 3 build plates (Search for NO AMS on the names) that are not flat and are being raised so that you can enjoy printing these coasters without AMS :)

At layer #13 (2.12mm) add a pause and switch to your desired color and that's it!

Only one color swap!

Couple Notes:

Before you send it to your print, check that the bottom of the coaster is sliced properly with the correct colors. The bottom side is the side with the drawing and the top should be in plain color.

For example, this is the top view after the slice:

This is the bottom view after the slice:

Hope you enjoy and share your printings :)