Decorative bow

I present this blue decorative bow

The version with the magnet is at the following link:

• https://makerworld.com/it/models/3090673-elegante-fiocco-magnetico-a-calamita-blu-marino#profileId-3482316

You can find my other bows at the following links:

• https://makerworld.com/it/models/2466442-pink-or-fuchsia-decorative-bow#profileId-2707555
• https://makerworld.com/it/models/2762147-sakura-pink-decorative-flake-with-magnets#profileId-3066630
• https://makerworld.com/it/models/3087958-elegant-magnetic-bow-sun-yellow#profileId-3478864
• https://makerworld.com/it/models/3089652-elegant-magnetic-with-magnet-magenta-bow#profileId-3481030

The model faithfully imitates the shape and folds of a fabric or satin ribbon

Model Features

• Material: Printed in PLA Bambulab basic Blue, it consumes only 12 grams of filament
• Realistic Effect: The design reproduces the three-dimensional curvature of the bow loops and the dovetail cut on the lower ends
• Use: can be used as a decoration

To achieve the cleanest model possible, I printed it vertically with rafts and supports

The model can be enlarged or reduced as desired 

The external supports detach easily, while for the internal supports you will need to use tweezers to grasp and remove them (be gentle). While removing the supports, do not stress the dovetail ends. If I succeeded, anyone can succeed

However, I have included a modifier (do not touch it; it serves to strengthen the dovetail ribbons)

GENERAL TIPS

One piece of advice I always give is to first clean the print bed with dish soap and a sponge, rinsing with hot water, then drying it with compressed air, avoiding touching the surface with your hands. I also recommend performing the dynamic flow rate and flow rate calibrations provided in Bambu Studio. Personally, before printing, I dry the PLA with AMS 2 PRO for about 1 hour. It is these small precautions, along with many others, that determine the success of a good print

Before leaving negative reviews, please adjust these parameters. If you have difficulties or continue to encounter problems, do not hesitate to contact me; we will work together to find solutions in a perfect collaborative atmosphere. I have made several prints of this object, and they all came out perfect as in the photos: if you have incorrect parameters, dirty or clogged nozzles, poorly calibrated machines, damp or poor-quality filaments, do not blame me

PRINTING INSTRUCTIONS:

• Layer height 0.2 mm
• Initial layer height 0.2 mm
• Wall loops 2
• Top shell layers 5
• Bottom shell layers 3
• Infill 12%
• Infill pattern Grid
• Supports Yes
• Raft Yes (raft layers 3 – raft Z distance 0.15 mm)
• Outer wall speed 200 mm/s
• Inner wall speed 300 mm/s
• Normal print acceleration speed 8000 mm/s
• Outer wall acceleration speed 8000 mm/s