Search models, users, collections, and posts
Hydraulic Quick Connect Bracket
IP Report
Print Profile(1)
bracket top & bottom, 0.2mm layer, 6 walls, 20% infill
Designer
6.3 h
2 plates
Open in Bambu Studio
Boost
0
2
0
0
1
0
Released
Bill of Materials
List other parts
- M8x1.25x50+mm bolt x 1: anchor bolt length depends on what you are going into/through. Mine was on top of other hydraulic piping, so the bolt was 70mm long.
- M8 washer x 1: for internal anchor bolt
- M6 washers x 4:
- M6x1.0 nuts x 4: inserted during a print pause, see description
- M6x1.0x50mm bolt x 4: connects bottom and top of bracket
Description
This bracket is to hold two Summit Hydraulics 1/2" Ag ISO 5675 Hydraulic Quick Connect Couplers. It may fit other ISO 5675 couplers, but I haven't tested that.
The four M6 nuts get inserted into the bottom part of the bracket at a pause in the .3mf file at 37.4mm. The M8 anchor bolt goes into a tapped hole on the tractor.
I printed in PETG-CF.
The TPU gasket/tray print profile is just to keep the bracket from rotating since there is only one anchor bolt.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)