Pagoda
Pagoda
Boost
10
18
16
Print Profile(3)
standard print for four side pagoda - 0.2mm layer, 3 walls, 15% infill
39 min
1 plate
standard print for pentagram pagoda - 0.2mm layer, 3 walls, 15% infill
44 min
1 plate
coloured pentagram pagoda - 0.2mm layer, 3 walls, 15% infill
59 min
1 plate
Boost
10
18
16
0
63
53
Released
Description
A small pagoda for my zen garden set.
Can be printed in the 4 sided version, pentagram version or the hexagonal version.
Print base and roof and just stack them (no support needed).
Zen garden can also be found here: https://makerworld.com/de/models/25421
Comment & Rating (16)
All
Print Profile
standard print for four side pagoda - 0.2mm layer, 3 walls, 15% infill
good print
1
Reply
Very good thanks. Just got to work on the flotation.
0
Reply
One more - this time in colour
0
Reply
Print Profile
standard print for pentagram pagoda - 0.2mm layer, 3 walls, 15% infill
Good👍
0
Reply
Again another cool print - Pentagram-Style!
0
Reply
Cool model - easy to print, perfect press-fit
0
Reply
With such a shallow overhang on the roof, did you need to tweak certain settings in the slicer? it seems if I try to print anything less than say 40 degree incline, the part sags or fails.
The designer has replied
0
Reply
Then you should check the calibrations of your printer.
With most printers an overhang of 60° (so 30° from horizontal) will work.
This model only has 45° on the outside. Only the inner "half dome" is shallower. But that should work, as it is only bridging.
0
Reply
Print Profile
standard print for four side pagoda - 0.2mm layer, 3 walls, 15% infill
Only printed the roof as I was testing my printers capability. Print was really fantastic.
0
Reply
Print Profile
standard print for pentagram pagoda - 0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
standard print for four side pagoda - 0.2mm layer, 3 walls, 15% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld