Flower Cookie Cutters

A variety of flower cookie cutters, right on time for spring! The cookie cutters are designed for thinner doughs of 4-6mm thickness. Some shapes are more difficult to get a good imprint of than others. Make sure to cover the cutter side with flour and roll your dough onto flour or a different non-stick surface. The dough should also not be too wet, sind that will make it way harder to get the dough ot without damage. If the dough is stuck, try tapping the cutter from the upper side repeatedly (maybe with some force), until the cut cookie comes out. 

Print from PETG for it to be cleanable with hand warm water. Clean thouroughly after each use as FDM prints are prone to bacteria! Not dishwasher safe (max 60°C!

For all of my models that include supports, I highly recommend a detailing / support removal tool like the one from anish or C59. Those make use of a replacement filament cutter and have proven themselves a very valuable tool for clean and easy support removal, especially for threads. 

Also, please keep in mind, that the quality of threads is highly dependent on the quality and dryness of your filament, the calibration of your printer and the print resolution. A thread printed with .2mm layer height will be way harder to thread nicely and will require more force, than a thread printed at .08mm or .12mm layer height. Also, the Arachne wall generator does contribute a lot to precise threads. If you need more part strength, increase the number of walls, make use of the alternate extra wall feature and DO NOT use PLA.

If you like my work and want to support me, please consider boosting or buying me a coffee :)