PC4-M6 release button

Found yourself with a broken release button on your PC4-M6 PTFE connector? Before you toss it away, here is the 3D-printed fix! I designed this replacement button specifically to repair damaged pneumatic fittings without needing to replace the whole part.

💡 Printing Tips

• Recommended Material: Use PA (Nylon) only. Its superior layer adhesion and mechanical toughness make it the best choice for this functional part.
• ⚠️ Warning: Avoid using PLA, PETG, or ASA. I have already tested them, and they tend to snap easily due to the mechanical stress. Nylon is the way to go for a long-lasting repair.

🛠 Assembly Note

If the PTFE tube doesn't slide through the hole easily due to filament tolerances:

1. Hold the button firmly with a pair of pliers (do not hold it with your bare hands to avoid injury!).
2. Gently clear/enlarge the hole using a 4mm drill bit—a tool every maker surely has close by! :D

I hope this helps you save some hardware!

• For a successful print it is mandatory to use the Bambulab glue stick on the build plate.

•  If you have printed my model, please leave a comment with a photo and feedback, Boosts are highly appreciated if this model worked well for you, thank you very much!

   

• If you encountered printing issues, report them to me immediately so I can correct any errors.
  
   

👇🏻👇🏻👇🏻Check out my other models too👇🏻👇🏻👇🏻

👉🏻👉🏻👉🏻⭐️⭐️⭐️⭐️⭐️🤩 https://makerworld.com/it/@xSolowJonel/upload 🤩⭐️⭐️⭐️⭐️⭐️👈🏻👈🏻👈🏻