Search models, users, collections, and posts
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
2.5 h
4 plates
Open in Bambu Studio
Boost
2
6
1
0
3
4
Released
Description
Content has been automatically translated.
Printing with PETG or PETG CF offers better strength, and there are two printing methods for supports
When removing PETG supports, it is recommended to use needle-nose pliers to twist them off from the side, and any remaining small supports can then be removed with pliers or sandpaper
When using sandpaper, pay attention that the tip must maintain a thickness of 0.5mm and the neck (connecting section) must maintain a thickness of 1.6mm, as being too small will affect the deburring process
- PETG+PLA: Because the two materials are incompatible, supports can be easily removed, and even no sanding is required (AMS is required)
※ The tip cannot withstand too much lateral force, or there is a risk of breakage
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)