Search models, users, collections, and posts
A1 Top Hat
IP Report
Print Profile(1)
0.28mm layer, 2 walls, 15% infill EASY
Designer
36 min
1 plate
Open in Bambu Studio
Boost
2
5
2
3
6
2
Released
Description
A little hat for your A1!
HOW TO PUT ON
- Remove the AMS mount from the printer
- Slide the top of the hat through the bottom of the AMS mount.
- Push the hat up a bit and press AMS back in place, once done make sure hat is firmly around the AMS
Troubleshooting
- If the hat is too loose, I suggest adding a couple layers of loose-ish duck tape around the inside.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (2)