Keycap Fred the Frog

The "Fred the Frog" keycap is a fun and quirky addition to your keyboard. This keycap is sure to bring a smile to anyone's face.

To achieve the best results with your print, it is recommended to use a nozzle size of 0.4mm or smaller and set the layer height to the lowest possible, at 0.1mm or lower. For the highest level of detail, resin printing is the recommended method. Additionally, due to the complex nature of the design, it is important to use supports during the printing process.

Photo of a make kindly provided by Tobias Gölzer:

Please consider liking, downloading, and sharing to spread the joy of this unique keycap design.

A special thanks to:

Thank you to rsheldiii the designer of the parametric keycap model.

Thank you to Fragaile the designer of the Flat keycap (Cherry MX).

Thank you to Fukus the designer of the Fred the Frog but in an smooth hd version.

Without these talented creators, this remix would not have been possible. Shoutout to these awesome creators for their contribution to the 3D printing community!

Some models are fanart and are shared as artistic tributes, you may not sell, share, or profit from them. For original designs, a commercial license is required to sell physical prints (available on Maker World or Patreon).