Search models, users, collections, and posts
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
0.16mm layer, 2 walls, 15% infill 200mm width
2.6 h
1 plate
Open in Bambu Studio
Boost
94
162
50
8
259
220
Released
Description
As the hueforge results increased and started to spread around the room, I made a picture stand to properly collect them and keep them upright.
Because the frame takes a lot of time to make and limits its size (it takes away time to produce the picture print), it was made in a simple form.
I aimed to create a structure that could withstand sizes below 200*200mm, but we did not check that size, but we confirmed that the 150*170mm size was well supported.
Since the content was written using a translator, the words may be awkward.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (50)