Search models, users, collections, and posts
Posts for slatted frame
IP Report
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
16.1 h
1 plate
Open in Bambu Studio
Boost
2
9
0
0
5
3
Released
Description
Content has been automatically translated.
I needed an elevation for my slatted frame because the delivery time for the bed was delayed by several months I printed 4 posts for each long side The slatted frame rests in the middle The rounded side faces outwards It is slightly lower than the inner peg because there were screws on the slatted frame that protruded over the wood The peg on the inside is placed between two slats It prevents the post from moving significantly Printed with Sunlu PLA 2.0+ in Chestnut Black with standard settings It has been very stable for several weeks
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)