Search models, users, collections, and posts
Inclinometer
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
3
5
0
0
1
0
Released
Description
Content has been automatically translated.
Part to be used with a 180° protractor with a thickness of about 3mm.
It has a marking to place the center of the protractor in its center, which is important for correct measurement.
You will need to get a small weight, which can be a nut, screw, or rubber band tied to a string attached to the center of the tool.
The two ends are for proper support of the tool.
I recommend not printing the tool in black if the protractor is transparent.
Depending on the thickness of the protractor and the position of its center, you may need to make adjustments to the inclinometer for correct measurements.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)