Search models, users, collections, and posts
power hack saw
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 30% infill
Designer
15.8 h
4 plates
Open in Bambu Studio
Boost
26
80
5
1
32
5
Released
Description
Content has been automatically translated.
My coping saw is based on the saw by Tomlie_Xie from Thingiverse.
His coping saw does not clearly specify which motor is used. Furthermore, he clamps the geared motor to the motor itself instead of attaching it to the gearbox. I utilize the FC-555 12V 4500 66RPM DC12V/DC motor (Amazon).
Additionally, I employ standard LM8UU linear bearings, of which I have a surplus from an old 3D printer. Four 608 ball bearings are required for the saw blade guide, and two 625 ball bearings are needed for the connecting rod.
Standard 70mm x 105mm hardware store metal hinges are used. The vise is a Röhm with an 80mm jaw width. Automatic shutoff is achieved via a 12V relay. When the limit screw contacts the lower limit stop, the relay opens.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)