Search models, users, collections, and posts
Roborock QRevo maintenance stand
Remixed by
IP Report
Print Profile(2)
0.6 nozzle, 0.42mm layer, 2 walls, 7% infill Gyroid
Designer
1 h
1 plate
0.4mm nozzle, 0.2mm layer, 2 walls, 7% infill
1.4 h
1 plate
Open in Bambu Studio
Boost
98
401
61
13
491
411
Released
Description
The Roborock QRevo “turret” is positioned off-center, so the original four arms of the stand were a bit too long. I scaled the original down by a factor of 0.85 and then increased the hole in the middle again to about 72 mm diameter by cutting it out.
- fits Roborock QRevo vacuum & mop combo
- hole: 72.4 mm diameter
- height: 23.8 mm
- arm length: ~ 61 mm
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (61)