Search models, users, collections, and posts
Charging Card Holder for Smart #3
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
5
10
1
0
30
13
Released
Description
Content has been automatically translated.
This is a holder for charging cards
The holder goes into the existing holder in the armrest of the Smart #3
Approximately 8 charging cards fit inside
The two rectangles then need to be glued to the bottom
I put a lot of time into designing and optimizing my models. If everything worked out, I would be thrilled about a 5-star rating ⭐⭐⭐⭐⭐ and a photo of your finished print! Your feedback helps me to further improve my models
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)