Came out great. a little tough getting all the support out, you have to be patient, but it all came together smoothly. The assembly was shown on the makerworld browser and although a little fast, gets the job done. I was having issues with my PLA tricolor silk on specific layers 60-100 but otherwise things went smoothly (filament issue) Few random notes for future printers: I would say to lessen the thickness of the brim supports if you aren’t as worried about plate adhesion as they are pretty thick by default settings as of 05/28/2026. the inner-chamber support was hard to scrape off effectively and I ended up scratching it a bit even with the right tools. some basic support modification may save you some time. The screws went in snug and I was not worried about snapping, though I used PLA. PETG might cause issues. The mag “snatch” or “latch” doesn’t properly catch, its off by a mm or two. Not sure if this was intentional. 24 hrs for first plate and 20~ for second.