This was a 6 day print, scaled up to the maximum size the H2D could print and had a friend airbrush for me. On the stand it sits just above 500mm high. Looks amazing, the photos look great but even better in person.

Fantastic print, will upload a photo when finished. Edit. Re-printed as a multi color print for a 10yo birthday. Looks awesome, photos do it no justice.

First I printed the old version in ABS which warped in the HT and spilt silica beads everywhere. (Turned out the AMS was getting stuck rotating the spool, the frame was too tight on the driven roller so not a design fault.) Printed the new version in ASA and run 2 dry cycles with no issues, the improvements work well retaining the lid better also. I have designed a transfer lid if required, it fits onto the spool the same as the lid to easily transfer silica without spills. It can be found here: https://makerworld.com/en/models/2477556-ams-silica-dryer-spool-transfer-lid#profileId-2721080

Printed perfect however the threads were a little tight for me, printed using ABS. I designed some spanners to facilitate tightening and loosening if anyone else has the same trouble. Link; https://makerworld.com/en/models/1844801-desiccant-spool-spanner#profileId-1971318

First print i got a hole at the back, while watching it print the second time i could see why, there is a small defect in the model (see picture).

Had a 409 conflict error however I just ignored and sent it, Printed great

Perfect fit. Thank you.