Created a little plaque for the poker chip holder. Slides and holds itself into the poker dispaly nicely. This display is for a 1.5"x4" plaque but 3d model is included to adjust as needed to any sized plate. This can be printed without any supports on the front, but I was getting drooping at top of the plaque area so added support to keep solid line across. Recommend using interface material (I used PETG on wood PLA) so that it keeps super clean and there are no support lines etc. Enjoy!

Simple end cap of original file to use if you just want to use 1 panel for very small display for challend coins etc. Referenced model used - https://makerworld.com/en/models/1071513-poker-chip-display#profileId-1061504

Needed a backlight for lithophane mothers day gift so created this simple stand/enclosure for the light, enjoy!