Hi, thanks for this excellent model. I printed with ABS on a X1C and it came out perfectly. Amazon does not ship most of the parts to Europe. I am including here the Amazon.de links of my purchases: 1. Extrusion Bar (https://www.amazon.de/dp/B0BWRVHX2V) 2. Extrusion Nuts (https://www.amazon.de/dp/B0DGSMZNJR) 3. Threaded inserts (https://www.amazon.de/dp/B07YSV66Y5) 4. Screws (https://www.amazon.de/dp/B0FBWX6HK2) 5. Extension Hook Spring (https://www.amazon.de/dp/B0DHXGXP3P) 6. Thumbscrews (https://www.amazon.de/dp/B0CHW8P2X8) 7. Soldering Iron(https://www.amazon.de/dp/B0CNXJJCXY) The handle is a little bit too thin and needs to be thickened with some layers of tape. Assembly is straightforward and the Assembly View of the .3mf, although not fully elaborated, is sufficient. The original soldering iron (https://amzn.to/3GU2rTj) is functionally better than the one of point 7, but it cannot be switched between 110V and 230V and, thus, requires a voltage converter in Europe.

These are really nice and interesting models with a lot of fun-potential. Printing and assembling went well thanks to the detailed assembling instructions. I have only a few minor suggestions: Truck: - The rear differential works sometimes a bit rough. Probably greasing would have helped, but this was not recommended in the instructions. - The preset value of 35° for the minimum angle of the Angular Servo caused the servo to rattle at maximum steering angle. 45° worked better Remote (Lithium Battery Version): - When printing the tops of the joystick, they lost adhesion. Maybe its better to print them separately. - Thanks for the new hint to order the power switch, in addition to the Lithium battery. I had missed that. - When mounting the controller in step 11, the cable of the power switch should be inserted. Later it is impossible. - Mounting of the cover with switch (Steps 22-25) should be before mounting of the smaller cover (Step 21). The current sequence does not work.

Thanks a lot. I only required the AMS pods and the Claymore pods with round hygrometer. The latter turned out to print perfectly also without support on my X1C. For these, I am using a small stand, which eases filling up. Might be added to ono of your plates.

Perfect. Thank you. Probably, I'll use TPU for the feet, next time.

Came out perfectly on my X1C and snaps in and out nicely. Thank you. Is it expected to open on rotation? Mine don't