misterphoton

cover

OpenGrid_Parts_2026-Feb-22_05-48-45PM-000_CustomizedView27668701522.png

opengrid-sabrent-4-port-usb-hub-1.png

opengrid-sabrent-4-port-usb-hub-2.png

opengrid-sabrent-4-port-usb-hub-3.png

openGrid Mount for Sabrent 4-Port USB 3.0 Hub

A combined collection of OpenGrid and Underware resources for organization!

OpenGrid & Underware

Accessories I've either printed for my H2S/AMS 2 Pro, or I'm considering printing for them.

H2S Accessories

I ended up adjusting the print orientation to avoid the entire bottom face being tree supports - in hindsight I should've painted in supports under the vent slots, but no one can see the bottom when the device is sitting on the base, anyway. Great design, fits perfectly with the Jetson AGX Orin Dev Kit - I still can't believe they didn't ship this with a bottom cover.

massif

Nvidia Jetson AGX Orin Developer 底壳

0.2mm 层高, 3 层墙, 10% 填充

0.2mm layer, 3 walls, 10% infill

Print profile is great, tolerances are perfect. Printed 4x each of the screws and the medium size in PETG and they clip and hold sufficiently in my underware grid. Great work! (ignore the stringing in the photo, my blue filament hasn't been dried in ages)

TheJVH

Under-Desk Cable Tie for OpenGrid System

Dual color - 0.12mm layer, 3 walls, 25% infill

I don't know if maybe there are slightly different versions of the DeLorean chassis piece that the stand clips to, but when I printed direct from the profile initially the clip was about 1mm too narrow - I could barely get it to clip onto the car. I went back and scaled it slightly larger and it clipped in much better. Both parts didn't friction fit with the vertical bar, however - I had to use CA glue to attach. Either way, it still looks awesome!

BrickDesigner

Back to the Future (77256) Delorean Display Stand

Full build with Studs

I took the advice from the designer and thoroughly dried my (very old) Amazon Basics transparent PETG before printing and the dessicant holders turned out perfect. It's downright amazing how the mesh prints - I spent a fair amount of time just watching my H2S laying down dots of filament.

DEFINITELY DRY YOUR FILAMENT FIRST! 