Worked well!

Simply amazing. Had some issues with the connectors. Printed and glued eyes and nose seperately since the flushing kept smearing on the head for the male bear

Amazing. There were some issues on the a1 so I had to reprint a few times. I used 2 profiles, the connector bits have been scaled down slightly do they fit correctly. Balloon on the main profile was slightly too heavy, used one from profile 2. (all on one optimized). Nose and fave bit had black smear on the top. I adjusted the walls and flush settings but kept having slight issues (might be the pla colors) that caused too much bleed. I cut off the nose and eyes and printed and glued these. Overall, as a small project and a gift I really enjoyed this design!

It's pretty good. I would recommend re sizing the the connectors by 2mm in length only (slightly under sized then vs too large). Apart from that the jayo white and black seemed to leave stripes around the eyes / upper part. I sort of fixed that by cutting of the eyes and printing it seperate. Still overall really high quality model!

Listing could be more clear, in the end it did work!