Search models, users, collections, and posts
Bio
I'm an active programmer for over 35 years. Lately i'm interested in desinging objects and dived into the 3d printing ecosystem.
Achievements
Pioneer Maker
Print successful 118 different models and 616 hours
MakerWorld Guardian
This badge has expired
Share
0
0
0
I've printed multiple Star Wars models of yours. They are all very well designed and easy to assemble. I only had some issues with the wing hole tolerances but it was very easy to fix using a utility knife. 5/5
Share
0
0
0
I've printed multiple Star Wars models of yours. They are all very well designed and easy to assemble. I only had some issues with the wing hole tolerances but it was very easy to fix using a utility knife. 5/5
Share
0
0
0
I've printed multiple Star Wars models of yours. They are all very well designed and easy to assemble. I only had some issues with the wing hole tolerances but it was very easy to fix using a utility knife. 5/5
Share
0
0
0
I've printed multiple Star Wars models of yours. They are all very well designed and easy to assemble. I only had some issues with the wing hole tolerances but it was very easy to fix using a utility knife. 5/5
Share
0
0
0
I used 98A and it’s very hard to flex but for 98A it’s kind of expected. Nice model.
Share
0
0
0
Share
0
0
0
this is exactly what i was looking for to test transparency results for different thickness values.
Share
0
0
0
Share
0
0
0
Eyes are very difficult to glue. I used a toothpick with a broken tip to apply the glue and tweezers to place the eyes. But eye orientation, which is left, which is right was totally random. You have to be ok with what looks ok. Other than that glueing cape to body is very difficult since tolerences are a bit high and touching surfaces don’t align good enough. But at the end it’s still 5/5 because of the outcome. Just be aware it requires some skills to assemble even if not too high skills.
Share
0
0
0
Model is beautiful. I had a printer issue (probably due to some sd card failure, nothing to do with the model). So, now i have an extra little plate. ;)
Share
0
0
0
I used this model as my first TPU print. I wasn’t sure about the settings. It still turned out pretty well.
Share
1
0
0
Share
0
0
0
This is a small gadget designed to make reading books easier. While many similar tools work well indoors, they struggle in windy conditions as pages tend to flip. This model solves that issue thanks to its wider and straighter design.
Windproof Book Page Holder
52
150
Share
0
0
0
I slowly printed it in 11+ hours to make it shinier and it worked very well.
Share
0
0
0
Share
0
0
0
Share
0
0
0
Natural silk gives the metal feeling very well. Very nice model.
Share
0
0
0
Printed without any issues. Very nice no-support design.
Share
0
0
0
Even if the cable ls not exactly the same model, it fits good enough.
Share
0
0
0