My first TPU 95A print. was in a bit of a quandary about feeding directing to the head, feeding via external spool holder or going via buffer. Went via external spool holder and in through rear feed (no buffer). little bit of string on corners but cleaned up fine.

found the lids to be a little too snug - as I printed in PLA I won't be recharging the beads in the oven in the cases - so I sanded the edges of the lids to make sure I could open them up more easily.

Review Update (Dec 1st). I have upgraded review to 5 stars. As I commented below, I changed two things at same time yesterday - the glue and the tweaks to the initial layer and flow ratio below. Maybe all it needed was better applied glue. I haven't done a manual flow rate calibration - but I will try today thanks. --- I had some adhesion problems with my Engineering V2 plate with P2S and Bambu PETG-CF I was using Creality Glue stick and may not have had a very even coating. I purchased some Elmer's washable clear liquid glue and used that instead. I also changed the following in the profile: Initial Layer Line Width to 0.6 mm Flow Ratio to 1.0 (from 0.95) Initial Layer to 20 mm/s Initial Layer Infill to 30 mm/s There was a couple of fast movements which raised some material but seemed to squish back down ok. just waiting for it to cool down to remove. Nice design. thanks. First layer photos are before I changed settings and glue type.