I have been looking for this!

printed great .Thank you for sharing!

This printed great ! Thank you for sharing Enough room to also store extra blades in a box the wall charger.

I only used the end pieces thank you for sharing

I love these printed perfect! Thank you for sharing off to find a tea light!

zero problems printing thank you for sharing

They printed great. have not used them yet. Thank you for sharing

I like these they printed great Thank you for sharing

I was worried after seeing this from my device. I am not sure what happened on the last leg of printing because I was asleep. I can sand a bit to remove some of the flaw in my print. I am so happy with this thank you so very much for sharing! The raised wolf is just fantastic!

Works great for Elegoo Cardboard (Rapid PETG) spools. I made a couple of them thank you for sharing

Large Medium and small is what I printed. This is probably once of the very 1st PIP that actually worked without breaking for me. Thank you for sharing! is there anyway we can get a smaller version of the small one ?

printed great Ty for sharing

I really like this, however it takes a day to print all 4 that connect together. I made a mistake and had tree supports on the inside (on one) it was bad to remove so don't do what I did.. LOL It's a f ton of desiccant too maybe to much. I wish there was a side hygrometer as for me i can fit 6 under my table and i could put 8 under a desk if it had a side hygrometer. All in all I like it Thank you for sharing

I like this idea but wish it was a universal one that fit all spools. Thank you for sharing

I really like this idea I printed out 2 of the petg ones. They are Hard to put in! Thank you for sharing

It printed great and in a timely matter. I was not paying attn to the box used. So this does not fit in the boxes I have I have the sterilite ones. I wish this would fix because the one i printed I really liked! Thank you for sharing. I printed one plate and the connectors.

It printed great and in a timely matter. I was not paying attn to the box used. So this does not fit in the boxes I have I have the sterilite ones. I wish this would fix because the one i printed I really liked! I did not do the dry box I did the connectors and one plate. Thank you for sharing

it is bulky, it does work fine its just big. Thank you

This Printed Great and its HUGE! Thank you for sharing!!

I just started on this and was using transparent PETG. I used the PC app and I am pretty sure that I seen supports when I sliced it, however there was no supports used in printing. So the edge on the front top had a bunch of stringing and was not completely fused with one another. Still printing parts But so far its looking beautiful with PETG Translucent. Will Update when everything is Done and ready for a photo shoot! Thanks for sharing