Search models, users, collections, and posts
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Pioneer Maker
Print successful 128 different models and 1,711 hours
Just released my 25mm RFID holder collection for Bambu Lab spools 🙂
This leaves the inside of the spool open for a nicely fitting silicon drying cilinder. So i needed a holder very flat for the outside of my Bambulabs spools.
Optimized for easy printing on Bambu printers.(Edited)
25mm RFID Holder Collection for Bambu Lab Spools
4
23
Share
0
0
0
Hope to see more models. details are just amazing. Printed on P1s with just standard settings
Share
0
0
0
printed in rainbowcolor silk pla. came out perfect. kid loved it
Share
0
0
0
came out very good. had to push the brim out an gave me an idea. after placing the bolt with ca glue i turned over the leftover colored brim and glue it on top. leaving it to dry proper niw and then cut it. i figure it will cover and seal the nut. just an idea 😅
Did not had photo yet after cut, its still drying up now :)
printed with PETG on P1S, standard setting. raised the bed temp 5 degr, just to be sure it would hold. printed 4pcs at once..
Share
0
0
0
Seat Ibiza 6J 2012 Fuel Cap Tether.
Printed in standard Black TPU and standard settings.
To replace the broken Fuel Cap Tether on my car.
This is my first upload so sorry if something isn't correct posted.
Hope you can use it.
Seat Ibiza 6J 2012 Fuel Cap Tether
12
21
Share
0
0
0
just lovely, puts a grin to everybody that goes to the toilett
Share
0
0
0
Share
0
0
0
No more data